Continue to hold the reset button until the power light starts flashing. Step 10: While holding the reset button, plug the power cord into the router.The button protruding from the back is the EZ Setup, which is not what you want to press. Step 9: Press and hold the reset button on the back of the router - Note that the reset button is recessed and you need a pen or paper clip to press it in.Step 7: Unplug the power cord from the router.Step 6: Open a command prompt window, and go to the folder with the four files.Step 5: Turn off the firewall on your PC - you need the TFTP program to be able to connect out through the firewall area to the router.Step 4: Set your PC to static IP 192.168.1.2 ( guide).Step 3: Connect your computer via Ethernet cable to a LAN port on the router.Step 2: Make sure you have a TFTP client available on you pc.Step 1: Copy the four files mentioned above to a folder on your pc. bin file shown on Supported Hardware list. Principle steps: a) set PC to static IP: 192.168.1.2 ( guide)ī) set router in recover-mode and load x (note: to set recover mode, unplug power from router, wait 30 seconds, press and hold reset button, plug in power)Ĭ) set router in recover-mode and load x d) set router in recover-mode and load dd-wrt-v24_mini_x fileĮ) from with-in dd-wrt-mini web-GUI load any suitable dd-wrt-v24_mega_generic. bin (file as shown on Supported Hardware - type wl5 to get the list) trx (file as shown on Supported Hardware - type wl5 to get the list) File Pack which contains both the x and x.connect PC and Router through wired connection!.Commandline - Asus WL-500 series example OS X ships with a command-line TFTP client, and the commands listed for linux will work.or install ATFTP, which supports autocompletion and history, with sudo aptitude install atftp.Ubuntu: install TFTP client with command sudo apt-get install tftp.Free command line TFTP client utility for any Windows versionĬommand is: tftp.exe -i -v 192.168.1.1 PUT dd-wrt.v24_mini_x Linux.No-nonsens open source TFTP tool, Tftpd32 includes TFTP client as well as DHCP, TFTP, SNTP and Syslog servers.Navigate and select the firmware file you wish to flash. The Server/IP address is that of the router being flashed. Simple Windows GUI TFTP Utility: Windows GUI TFTP Utility (tftp2.exe).Windows Features -> check mark : TFTP Client You need to enable it in Control Panel -> Programs and Features -> Tftp client is enabled in the default installation of WinXP Different windows TFTP options are listed below. You can use a command line client, its quite easy really - or you can choose to use a GUI version. With TFTP, all of the information about the transfer is specified during the initial command/setup there is very little client/server interaction compared with standard FTP. 4.6 Transfer the Temporary Asus DD-WRT Firmware.4 How to Install DD-WRT onto an Asus WL-500W Using Ubuntu Linux.2 Commandline - Asus WL-500 series example.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |